Skip to main content

Made by a Fabricista: Charlie Caftan Meets Nanette Lepore!

During summer I am able to sew much more than I can sew in the rest of the year.  Since I teach full time (middle school!), I find I am so busy that I can only sew a project (or two) a month during the school year.  But summer?  I get all my sewing mojo back and really get into gear.  This last make for the Fabric Mart blog for this summer is probably one of my all time favorite makes, ever.  I knew I would be heading to Mexico on a cruise with my aunt, and I knew I would want to bring this Burda dress I made for this blog in July, so I asked the folks at Fabric Mart if they would send me some yellow green Nanette Lepore fabric with red, green, and white accents along with a Charlie Caftan pattern (by Closet Case Files), as the two pieces would serve together well as a base for the rest of my travel wardrobe.

I wore the dress/coverup in Mexico as a coverup, but I ended up wearing it last Sunday as a dress, and it does serve both purposes quite well.  As a coverup, it looks nice and put together enough that you could run into a store or two and not look too much like you had just been at the pool or beach, with the added bonus of the fabric itself not wrinkling too badly.  I really love this fabric.  It looks like a linen, but in reality is a thick cotton with a soft structure.  Very easy to work with, very easy to wear, and very easy to wash and dry.  Good stuff.  (Here is how the designer used the fabric as a sleek sheath dress.  Here is a jacket made from a similar weight/design fabric.  And here is the collection so you can see the whole lot--Fabric Mart carried quite a bit of her fabric from this collection--Spring 2009.)

I want to point out that I did not make the dress the length meant for the sizes I cut (a 6 at the shoulders, bust and waist, and a 10/12 at the hips/low hip).  I ended up using the largest size's length, as I knew the drafted size 12 would hit too high on my leg (I am 5'8.5").  I may make this again, possibly in a smaller set of sizes for a sleeker winter over-dress (worn with a turtleneck and tights), and I would definitely draft that to have an even longer hemline.

Left to Right, Top to Bottom: 1. Carefully marked and staystitched corners with corner snipping. 2. Detail of corner snip. 3. Welt pieces lined up and ready to sew (I used two rows of gathering stitches). 4. Inset interfaced panel piece lined up with gathering stitched portion. 5. Stitched first line. 6. Pressed up and done!
Everyone and their sister and cousin and uncle have made this caftan this summer.  It is pretty much a universally loved pattern.  The only tiny issue people have with it is the same exact issue I have with it...the inset center panel.  It seems easy enough at first, but when you actually start the construction, you realize very quickly that you are basically making a welt pocket without a pocket.  The effect of the piece that is made with this construction is just beautiful, but it is time consuming and precise and fiddly.  If you don't use time and care with it, it may all be off and end up being more of a frustration.  Even with all my very carefully executed steps and markings, I STILL ended up off at one of the corners and had to topstitch there to ensure the panel laid flat.

The folks at Closet Case Files had a very well written sewalong on this Caftan, but I am going to direct straight to the inset panel instructions as the rest of the caftan is fairly straight forward.

Left to Right, Top to Bottom: 1. Lining up triangular piece from side portion of welt with side of inset. 2. Double checking markings for these two pieces lining up on the other side.  3. Once sewn, checking for proper 90 degree angle on right side.  4. All seams are sewn, so press up raw edges so facing piece can be placed over it.  5. From right side, this is what the inset piece will look like once sewn up.  6. After raw edges are pressed up, the facing piece is placed over them...I hand sewed this over the raw edges, but Closet Case has instructions for machine sewing it, as well.
The second set of photos shows the continued care you must take with this inset piece.  I keep thinking there must be some way of doing this so you can get the same effect without all the fiddling, but I haven't been educated in pattern drafting, so I can't speak to what possibilities are out there to take the place of this way.  The effort is worth it...the inset piece looks so pretty right above the gathering.  Some of the reviews I read said the gathering was too voluminous for them, but I really like the volume.  The rest of the dress is fairly sleek, so this gives the garment a bit of whimsy.

Here you can see the pockets in use.  The pockets are rather large, which I just love, but some of the reviewers of this pattern out there in the large world of the web are not as pleased with their size.  They seem easy enough to make smaller, so do that.  I wouldn't leave off the pockets, they really are just that fab.

Left to Right, Top to Bottom: 1. Apply the tape with paper backing UP.  Then press with a dry, hot iron.  2. Lift up paper backing and discard.  3. Carefully press hem up (I only did a half-inch, so the sticky tape bit came together here). 4.  Press to ensure it stays put.  Again, hot and dry iron.  I then stitched the hem.
I knew I wanted a 1/2" hem on both my skirt hem and my sleeve hem, so I went ahead and used SewkeysE double-sided knit stay tape.  The instructions are ridiculously simple, but I am a visual person, and I figure some of you must be as well, so I photographed four of the steps.

Two photos of me from Mexico, the top is of me at a resort where we purchased a day pass (it was stunning there, and even though it rained part of the time, it never felt so bad that we didn't stay in the water at the beach or in the pools).  The bottom is of me at the ship.  This is an older ship, and it was at full capacity so it was cramped, but I love people watching, and there were ample opportunities to do so.

I hope all of you had a wonderful summer!  I really look forward to seeing what others do with this pattern, or with the Nanette Lepore fabric.  See you in a few months!

Dina, My Superfluities.

Comments

Post a Comment

Thanks for leaving a comment! All comments are reviewed before posting to help us eliminate spam. Your comment will be posted within 24 hours.

Recent Posts You Might Like

Sewing With Intention: New Look 6106 and a More Coordinated Wardrobe

Sometimes a sewing project begins with a beautiful piece of fabric or a pattern you just have to make. This one began with my closet. Recently, I did a major closet purge. I took a good look at what I actually wear, what I kept reaching for, and—maybe more importantly—what was missing. Once the pieces I no longer loved or wore were gone, something became very clear: I want to be more intentional about what I sew next. Instead of sewing individual pieces that I love but don't necessarily wear together, I want to build a wardrobe where my handmade garments coordinate with the clothes I already own—and with the pieces I'm planning to sew next. For this month's Fabricista project, this beautiful lightweight shirting from Fabric Mart turned out to be a wonderful place to start. The Fabric That Started It All Fabric Mart provided this beautiful oatmeal and black heathered shirting , along with the matching thread for my project. One of the things I love most about this fabric is ...

The Perfect Plan for this Linen Blend! Until I Changed My Mind.

Hello Sewing Friends!  It’s Sharon from Sharon Sews with another Fabricista make.  When I saw this linen blend designer fabric on the Fabric Mart Fabrics website, I was intrigued.  After all, I, like many of you, love to find designer fabrics at an affordable price. It is a linen/nylon/rayon/Lycra blend, and I wondered what the designer had created with the fabric as I wasn’t familiar with that combination of fibers.  Surprisingly, I discovered a sleeveless, lined, mid-length vest in the same color with an almost identical fabric composition. Perfect! I’ve been wanting to sew a longer vest with matching pants, and that discovery confirmed this fabric would work beautifully for the look I had in mind.  The vest I’m wearing, from the June 2026 Burda Style magazine, it is not what I was originally going to make.  You see when I found the designer’s vest, I remembered seeing a Butterick pattern that was almost identical.  I ordered the pattern excited to...

Meeting Endless Summer Energy with a Maxi Dress

How are the temps still so hot?! I’m trying to make the best out of a blazing situation with a gorgeous swishy dress made in a splendid graphic print in an attempt to keep my cool when I am very much not. The heat persists, but so do I (while wearing sundresses)!  I really wanted a full length, all-fancy-design-details-included version of the new Chalk & Notch Noe Tank Dress since testing the pattern. This is View C. This version features a beautiful open back with a tie closure and the long gathered hem for maximum impact.  I chose the higher of two necklines. The pattern features full lining and I used the same fabric for both. I prefer to avoid any peeking-issues the easy way.  As I was scrolling through the challis options on the Fabric Mart site, this one stood out immediately, a beautiful kelly green with big abstract swipes of aqua. Simple, bold, (non-directional!), all of my favorite characteristics necessary for a showstopping dress. I wanted something very ...

Fall + Flannel = Shacket

If there is one piece that transitions easily between crisp fall mornings, mid-day warmth, and chilly autumn nights, it’s a shacket. Today, I’m excited to share my latest Fabric Mart make: the Ellie and Mac Patterns Connie Casual Shacket, sewn in a dreamy plaid flannel coating fabric . Here’s a glimpse at how it came together, along with a few construction tips for planning your own version! The Ellie and Mac Patterns Connie Casual Shacket pattern offers plenty of options needed to make the perfect transitional top layer for fall. With a relaxed body, oversized sleeves, three lengths, and a curved or straight hem option, you can make your dream shacket a reality.  For this sew, I selected a plaid flannel coating fabric with a soft blend of sage green and cream tones from the Fabric Mart website. Heavyweight flannel is ideal for a shacket because it provides structure and added warmth. As a bonus, this particular fabric is extra soft and snuggly, which I love. In addition to the fa...