Skip to main content

Reader's Pick Sew Along #2 - Bodice Pleats

Image
By
On Monday when I introduced Step #1 - Cutting, Alterations and Thread, I mentioned about lengthening and shortening the bodice piece. Since then, the person that asked about this tried it out, using the directions from Handmade by Heather B, and it worked! So if you haven't cut out of your good fabric yet and need to do this step, give it a try!

Since we are working with knits, it is important to make sure you have a STRETCH NEEDLE. One thing I found when I was starting to sew with knits, was that my seams and hems would break because there was no give. Knits stretch with you, the thread does not. Some sewing machines have a knit stitch. (Check your manual for this info.) If your sewing machine doesn't, set your machine to a straight stitch, but modify your zig-zag stitch ever so slightly. (Or use the zig-zag, but on a very fine zig-zag, almost straight! This setting depends on your sewing machine.) I have a Bernina and it comes with a knit stitch. I don't care for it, so I use a straight stitch with a slight zig-zag. 

Here is a photo of my settings: 

I do tug slightly on a knit when I'm sewing with it, but not too much. You don't want fabric ripples!

So today we're going to make the pleats for the bodice. I'm not going to go through every step they tell you to do, because that would just be repetitive, but give you hints, reminders and suggestions that go along with the step. 

When making your pleats you may fumble around with matching up your lines and sticking the pins into place. Starting from the end of the fabric, I pierce the pin through the line and then through the line on the other side of the fabric. This ensures that you've got one section all lined up. Then go back into the line with the pin and match up the line again. 



When sewing your pleats, be sure to keep the other pleats out of the way! You don't want to sew them all together! 

Listen to the directions with they say press and baste your pleats up or down! It definitely helps the dress look great in the finished product!  


 After your pleats are in place, use some seam binding to stabilize your shoulder seam. I used a transparent seam tape called, Seams Great Binding by Dritz.


That's all for today! This step was easy. The next couple of steps get more complicated. 

Share your fabric choices on our Flickr page! Some of you have shown us what you are using and we'd love to see more! 

Any questions or suggestions? Comment below. 

Comments

  1. dinagideonApril 9, 2014 at 10:49 AM

    Thanks for the great info. :) I want to add that I definitely stabilized the neckline bit, too, so that it wouldn't stretch out of shape when sewing it up. My muslin is far from perfect, but that darn neckline looked great. I *think* I may have used stay tape...

    When is the next part of the sew along set to go? I want to make sure I stay in step with you all and don't get behind. I have a few projects over the next few weeks, so I have to prioritize my sewing tasks.

    ReplyDelete
    Replies
    1. Fabric MartApril 9, 2014 at 10:02 PM

      Hi Dina, the next step will be posted on Friday. You will have all weekend to work on that. And for people catching up, they have the weekend to do also!

      Delete
  2. dinagideonApril 9, 2014 at 10:51 AM

    No wait, the neckline has stretch, so I must have used some kind of knit stabilizer. Will check my notes and dress muslin a bit further to see what I did to stabilize the neckline...

    ReplyDelete
  3. dinagideonApril 9, 2014 at 11:08 AM

    Okay, last comment, I promise. I just checked the neckline, and it appears I didn't use a stay tape or stabilizer of any kind. Sigh. What I think I did was staystitch the dress neckline to prevent stretching, but then used the "lightning bolt" stitch on my Bernina to get stretch on the finished bit of the neckline.

    I only remember this part so clearly because so many reviews of this pattern mention making sure to not stretch out the neckline or else it will gape. And that is the last thing I wanted from my finished product.

    ReplyDelete
    Replies
    1. Fabric MartApril 10, 2014 at 9:19 AM

      I did notice the neckline comment brought up a lot in other reviews of this pattern. We will talk about this in the next step, which will be posted on friday!

      Delete
  4. Sharon G NicholsApril 9, 2014 at 10:35 PM

    How do you feel about using clear elastic on the shoulder seams instead of stabilizer? I've used it and like it, but are there times stabilizer would be preferable?
    Thanx!

    ReplyDelete
    Replies
    1. Fabric MartApril 10, 2014 at 9:16 AM

      Hi Sharon,

      I think that clear elastic would be fine, as long as you don't pull on it to the point of puckering your seam. If you are comfortable with it, I would say go for it! The thing I liked about the seam tape I used was that it did not stretch, therefore I didn't have to worry that it would pucker.

      Delete
    2. Sharon G NicholsApril 10, 2014 at 3:57 PM

      That makes sense. Thanks for the reply!

      Delete

Post a Comment

Thanks for leaving a comment! All comments are reviewed before posting to help us eliminate spam. Your comment will be posted within 24 hours.

Recent Posts You Might Like

Sewing With Intention: New Look 6106 and a More Coordinated Wardrobe

By
Sometimes a sewing project begins with a beautiful piece of fabric or a pattern you just have to make. This one began with my closet. Recently, I did a major closet purge. I took a good look at what I actually wear, what I kept reaching for, and—maybe more importantly—what was missing. Once the pieces I no longer loved or wore were gone, something became very clear: I want to be more intentional about what I sew next. Instead of sewing individual pieces that I love but don't necessarily wear together, I want to build a wardrobe where my handmade garments coordinate with the clothes I already own—and with the pieces I'm planning to sew next. For this month's Fabricista project, this beautiful lightweight shirting from Fabric Mart turned out to be a wonderful place to start. The Fabric That Started It All Fabric Mart provided this beautiful oatmeal and black heathered shirting , along with the matching thread for my project. One of the things I love most about this fabric is ...
9 comments
Continue Reading »

The Perfect Plan for this Linen Blend! Until I Changed My Mind.

By
Hello Sewing Friends!  It’s Sharon from Sharon Sews with another Fabricista make.  When I saw this linen blend designer fabric on the Fabric Mart Fabrics website, I was intrigued.  After all, I, like many of you, love to find designer fabrics at an affordable price. It is a linen/nylon/rayon/Lycra blend, and I wondered what the designer had created with the fabric as I wasn’t familiar with that combination of fibers.  Surprisingly, I discovered a sleeveless, lined, mid-length vest in the same color with an almost identical fabric composition. Perfect! I’ve been wanting to sew a longer vest with matching pants, and that discovery confirmed this fabric would work beautifully for the look I had in mind.  The vest I’m wearing, from the June 2026 Burda Style magazine, it is not what I was originally going to make.  You see when I found the designer’s vest, I remembered seeing a Butterick pattern that was almost identical.  I ordered the pattern excited to...
4 comments
Continue Reading »

Fall + Flannel = Shacket

By
If there is one piece that transitions easily between crisp fall mornings, mid-day warmth, and chilly autumn nights, it’s a shacket. Today, I’m excited to share my latest Fabric Mart make: the Ellie and Mac Patterns Connie Casual Shacket, sewn in a dreamy plaid flannel coating fabric . Here’s a glimpse at how it came together, along with a few construction tips for planning your own version! The Ellie and Mac Patterns Connie Casual Shacket pattern offers plenty of options needed to make the perfect transitional top layer for fall. With a relaxed body, oversized sleeves, three lengths, and a curved or straight hem option, you can make your dream shacket a reality.  For this sew, I selected a plaid flannel coating fabric with a soft blend of sage green and cream tones from the Fabric Mart website. Heavyweight flannel is ideal for a shacket because it provides structure and added warmth. As a bonus, this particular fabric is extra soft and snuggly, which I love. In addition to the fa...
1 comment
Continue Reading »

Meeting Endless Summer Energy with a Maxi Dress

By
How are the temps still so hot?! I’m trying to make the best out of a blazing situation with a gorgeous swishy dress made in a splendid graphic print in an attempt to keep my cool when I am very much not. The heat persists, but so do I (while wearing sundresses)!  I really wanted a full length, all-fancy-design-details-included version of the new Chalk & Notch Noe Tank Dress since testing the pattern. This is View C. This version features a beautiful open back with a tie closure and the long gathered hem for maximum impact.  I chose the higher of two necklines. The pattern features full lining and I used the same fabric for both. I prefer to avoid any peeking-issues the easy way.  As I was scrolling through the challis options on the Fabric Mart site, this one stood out immediately, a beautiful kelly green with big abstract swipes of aqua. Simple, bold, (non-directional!), all of my favorite characteristics necessary for a showstopping dress. I wanted something very ...
Post a Comment
Continue Reading »